DIY: From Recycle to Roses

Can you believe these roses were made from TP cores? (You can also use the inner cardboard from paper towel rolls or wrapping paper.)

Folks, after making some TP core snowflakes and poinsettias a few years back, I was ready for a new craft (one only needs so many Christmas decorations). I decided to try this tutorial for making roses.

First, start by tracing a flower shape onto your flattened toilet paper core. You should be able to get one out of each TP roll or 3 out of a paper towel roll. Note: my flower shape has 8 "petals", but the tutorial used 6. I think both results are lovely.

Cut out the flowers, and paint them the color of your choosing. Once dried, you'll need 3 1/2 of these flower shapes to make each rose. You'll cut one petal out of one so you have 2 shapes (1 petal and 7 petals). Repeat so you end up with seven pieces: 7 and 1, 6 and 2, 5 and 3, and 4. You'll have a half-flower/4-petal piece left over for your next rose.

For each of the seven pieces, curl them up so the two flat edges meet, making a conical shape, and seal it with hot glue, super glue, or some other fast-drying and secure adhesive. I recommend against a glue stick (not strong enough) or tape (will end up very visible). I also recommend a small paint brush, popsicle stick or other implement to help push the edges together, so you aren't burning your fingers on hot glue or sticking them together with super glue.

One by one, glue each piece into the next (with just a dot of glue in the bottom of the larger layer), starting with the 7 petals, then 6, and so on, allowing the glue to harden between each.

Once all seven layers are together and glue dried, use your skinny paintbrush to help you curl the edges of each petal.Viola! You have a rose!

Optional: If you want to turn your roses into a larger craft, for example a wreath or a flower crown, you may want something attached to the rose to connect it to the larger piece. These roses have conical bottoms, so won't easily glue onto flat items. To help with this, I wove a floral wire through four points of the 7-petal layer, prior to gluing in the remaining layers.You could also do this with embroidery floss or other thick thread/thin ribbon.

Happy crafting!